- On sale!
600W HPS Ignator Sodium Bulb
€11.50
Tax included
The Ignator HPS 600W is distinguished from other lamps by its V-shaped metal structure with lateral supports in the top of the discharge tube. It is made with high quality materials to achieve a great photosynthetic efficiency and maximum ignition reliability.
Offers proven durability of 10,000 hours of use. Maintaining its performance at an exceptional level due to the Improved structure of the outer bulb reaching an intensity of 80,000 lumens.
The Ignator HPS 600w lamp can be used with any 600W power HPS/HPI ballast (transformer).
Technical characteristics:
- Power: 600W
- Intensity 80,000 Lumens.
- PPF 929.33 µmol/s
- Efficiency: 1.55 µmol/J
- Color temperature: 2050ºK
- Durability 10,000 hours 80%
- Voltage: 110V - 220V
- Ignition voltage: 3-5KV
- Nominal voltage_ 130V
- Intensity 5 A
- Lampholder: E40
- Diameter: 47±2mm
- Length: 285mm
- Optimum ambient temperature (ºC): 25
- Maximum lamp holder temperature (ºC): 250
- Maximum bulb temperature (ºC): 400
- Type of luminaires: Open
- Operating position: Any position.
Warnings:
- Do not touch with your hands, use a cotton or cellulose textile that does not leave residues or particles to manipulate the cold lamp.
- Never handle the lamp when it is hot
- Warning, danger of burns. The lamp reaches very high temperatures, install in equipment with protection.
- Do not look directly at the lamp, its high intensity could cause serious damage to the eyes.
- At the end of its useful life, recycle the lamp through the appropriate waste management process.
- Never turn on the lamp when it is hot. In the event of a power failure lasting a few seconds, the installation or the Lighting equipment must have a timed reset to prevent it from turning on when the lamp is hot. Wait at least 3 minutes before turning on again. Failure to meet this point shortens lamp life and voids warranty.
- Do not touch with your hands, always use a cotton or cellulose textile that does not leave residues or particles to handle the lamp cold. It is possible to touch the lamp holder when cold using a cotton textile or cellulose that does not leave particles on the lamp.
- Never handle the lamp when it is hot.
- Warning, danger of burns. The lamp reaches very high temperatures, install in equipment with protection.
- Do not look directly at the lamp, its high intensity would cause serious damage to vision.
- At the end of its useful life, recycle the lamp through the appropriate waste management process.
BOMB0105
Comments (0)
4 other products in the same category:
600W HPS sodium high pressure lamp for growth and flowering. With a spectrum where blues are averaged and red to promote the development of plants throughout their entire life cycle.