Prosystem Aqua Automatic pH Controller
€294.00
Tax included
pH controller consisting of a 0.30 l/h digital proportional pH reduction dosing unit and a 0-14 range electrode for its detection, powered by 220v and low power consumption.
The automatic pH controller is designed and prepared to regulate the required pH level in irrigation water, whatever the desired parameter. In this way and in a totally automatic and independent way, it will dose the product in proportion to the need by means of a simple pre-regulation, in which we indicate the level we want to maintain in the water tank.
What is included in the automatic pH controller
This nutrient controller comes fully equipped for its complete installation, including: pH electrode, suction and impulsion fittings, suction and impulsion tubes, pH7 solution and fixing bracket and screws.
Technical characteristics of the automatic pH controller
- Peristaltic pump with regulation proportional to the pH signal
- Automatic pH control
- pH operating range: 4-8
- Sensitivity: 0.1 pH units
- pH probe included. Model: SpH-1-S-1,5 (1,5 meters cable). BNC connector
- 4-digit 7-segment display
- 3-position switch: Priming, On and Stand By
- Dosing method ON:OFF, set point adjustable
- Calibration method: 1 point (pH 7)
- Pump can be programmed for both acid and alkaline dosage
672031
Comments (0)
5 other products in the same category:
pH controller consisting of a 0.30 l/h digital proportional pH reduction dosing unit and a 0-14 range electrode for its detection, powered by 220v and low power consumption.